Audi RS3 2.5 TFSI 400hp
Stage 1Bosch MED17.1.62Petrol2017 – 2020
470hp
- Factory
- 400 hp
- Gain
- +70 hp · +17.5%
620Nm
- Factory
- 480 Nm
- Gain
- +140 Nm · +29.2%
Figures are measured on a healthy, well-maintained example under ideal conditions. Your car is checked before anything is written.
- 100% custom made tuning file guarantee
- Tested and developed on a 4x4 dynamometer
- Best results made tuning within the safety margins
- A decrease in fuel consumption
Engine specifications
- Type of Fuel
- Petrol
- Method
- MadeForStreet
- Tuning Type
- Stage 1
- Cylinder content
- 2480 CC
- Compression ratio
- 10.0 : 1
- Bore X Stroke
- 82.5 X 92.8 mm
- Engine number
- DAZA
- Engine ECU
- Bosch MED17.1.62
- Gearbox ECU
- Temic DQ500
Systems included in this remap
- Decat
- DTC removal
- Pop & Bang
- Vmax removal
- Decat
- Decat is applied to cars that do not have a catalyst in the exhaust range. After removing the catalyst, the ECU will detect this, which may cause error messages. Therefore, this must be adjusted software-wise.
- DTC removal
- DTC's, also known as Diagnostic Trouble Codes, are electronic messages in cases of problems with the engine or transmission. They can be switched off when the causes are found and solved.
- Pop & Bang
- Pop and bang is the principle of antilag, but then in coast down condition.
- Vmax removal
- It is possible to remove the Vmax, which basically is a speed limiter. Nowadays, a lot of cars have a speed limiter and that means that the full potential of the car isn't reached.
Availability depends on what the Audi RS3 2.5 TFSI 400hp hardware already supports. We confirm the list for your car before any file is written.
Get a quote for your Audi RS3 2.5 TFSI 400hp
Tell us what you are after and we come back with the stage options, the expected figures and the price for your car. Faster on the phone —+1 (407) 205-9010.