Peugeot 308 1.6 THP 200hp

Systems included in this remap

• Decat
• DTC removal
• Start & Stop off
• Flaps
• Pop & Bang
• Vmax removal

Decat

Decat is applied to cars that do not have a catalyst in the exhaust range. After removing the catalyst, the ECU will detect this, which may cause error messages. Therefore, this must be adjusted software-wise.

DTC removal

DTC's, also known as Diagnostic Trouble Codes, are electronic messages in cases of problems with the engine or transmission. They can be switched off when the causes are found and solved.

Start & Stop off

A Start & Stop system is a system that is shutting off the engine when the engine runs stationary. The system can be turned off in a lot of cars via a button, but sometimes it isn't possible. For those cars, the Start & Stop system can be switched off in the engine management system.

Flaps

Flaps are small valves which vary the length / volume in the intake manifold to create a more beautiful coupling and more efficiency. The flaps can be deleted and can be switched off in the engine management system. Sometimes the flaps break down and when that happens, there is a great chance of damaging the engine.

Pop & Bang

Pop and bang is the principle of antilag, but then in coast down condition.

Vmax removal

It is possible to remove the Vmax, which basically is a speed limiter. Nowadays, a lot of cars have a speed limiter and that means that the full potential of the car isn't reached.

Availability depends on what the Peugeot 308 1.6 THP 200hp hardware already supports. We confirm the list for your car before any file is written.